Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 dhcp relay source-interface

Configure DHCP relay source IPv6 interface.

Syntax
ipv6 dhcp relay source–interface interface

To disable the DHCP relay source IPv6 interface, use the no ipv6 dhcp relay source–interface interface command.

Parameters
source-interface interface
Enter the keyword source-interface then the type of interface and the interface information:
  • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/plot information.

  • For a 10-Gigabit Ethernet information, enter the keyword TenGigabitEthernet then the slot/port information.

  • For a 40-Gigabit Ethernet information, enter the keyword FortyGigabitEthernet then the slot/port information.

  • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

  • For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The range is from 1 to 16383.

  • For a port channel interface, enter thee keyword port-channel then a number. The range is from 1 to 128.

  • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults
Disabled
Command Modes
  • CONFIGURATION

  • INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(1.0)
Introduced on the C9010, MXL, FN IOM, S3100 series, S4810, S4820T, S3048–ON, S4048–ON, S4048T-ON, S5048F-ON, S6000, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\