Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 helper-address

Configures the IPv6 DHCP helper addresses.

Syntax

[no] ipv6 helper-address [vrf vrf-name] ipv6-address

To delete the IPv6 helper address, use the [no] ipv6 helper-address [vrf vrf-name] ipv6-address command.

Parameters
vrf vrf-name
(Optional) Enter the keyword vrf and then the name of the VRF through which the host address can be reached.
ipv6-address
Enter the keywordipv6–address through which the server address can be reached.
Default
Disabled.
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(1.0)
Enhanced to support non-default VRF configuration for DHCPv6 helper address.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S4810, S4820T, S6000, S6000–ON, Z9000, and Z9500.
Usage Information

Use this command on the interfaces where the DHCP clients are connected to forward the packets from clients to DHCP server and vice-versa.

Example
DellEMC(conf-if-te-1/1)# ipv6 helper-address 
X:X:X:X::X     IPv6 helper address
VRF            VRF name.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\