Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 mld snooping mrouter

Configure a Layer 2 port as a multicast router port.

Syntax
ipv6 mld snooping mrouter interface {interface interface}
Parameters
interface
Enter the keyword interfaceto indicate the next-hop interface to the multicast router.
interface
Enter one of the following keywords and the interface information:
  • For a null interface, enter the keyword null then the slot/port information. The Null interface number is 0.
  • For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port information.
  • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
  • For a port channel interface, enter the keywords port-channel then a number.
Defaults
None.
Command Modes
INTERFACE VLAN
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.0)
Introduced on the S3048–ON, S4048–ON, S4048T-ON, S5048F-ON, S6000–ON, S6010–ON, S6100–ON, Z9100–ON, S3100, and C9010.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\