Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 name-server

Enter up to six IPv6 addresses of name servers. The order you enter the addresses determines the order of their use.

Syntax
ipv6 name-server ipv6-address [ipv6-address2... ipv6-address6]

To remove a name server, use the no ipv6 name—server ipv6–address command.

Parameters
ipv6-address
Enter the IPv6 address (X:X:X:X::X) of the name server to be used.

Note: The :: notation specifics successive hexadecimal fields of zeros.

ipv6-address2... ipv6-address6
(OPTIONAL) Enter up to five more IPv6 addresses, in the x:x:x:x::x format, of name servers to be used. Separate the IPv6 addresses with a space.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.4.2.1
Introduced on the C-Series and S-Series.
8.4.1.0
Introduced on the E-Series.
Usage Information

You can separately configure both IPv4 and IPv6 domain name servers.

In a dual stack setup, the system sends both A (request for IPv4 — RFC 1035) and AAAA (request for IPv6 — RFC 3596) record requests to a DNS server even if only the ip name-server command is configured.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\