Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 ospf area

Enable IPv6 OSPF on an interface.

Syntax
ipv6 ospf process id areaarea id

To disable OSPFv6 routing for an interface, use the no ipv6 ospf process-id area area-id command.

Parameters
process-id
Enter the process identification number.
area area-id
Specify the OSPF area. The range is from 0 to 4294967295.
Defaults
None
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.2)
Increased the area ID value from 65535 to 4294967295.
9.12(1.0)
Introduced on the S5048F–ON.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.1.(0.0)
Introduced on the S4810 and Z9000.
8.3.19.0
Introduced on the S4820T.
7.4.1.0
Introduced on the E-Series and C-Series.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\