Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 pim dr-priority

Change the designated router (DR) priority for the IPv6 interface.

Syntax
ipv6 pim dr-priority priority-value

To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.

Parameters
priority-value
Enter a number. Preference is given to larger/higher number. The range is from 0 to 4294967294. The default is 1.
Defaults
1
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.11.3.0
Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100, S6010-ON, S3048-ON, and C9010.
Usage Information
The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain the same designated router priority value, the interface with the largest interface IP address becomes the designated router.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\