Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 pim query-interval

Change the frequency of IPv6 PIM router-query messages.

Syntax
ipv6 pim query-interval seconds

To return to the default value, use the no ipv6 pim query-interval seconds command.

Parameters
seconds
Enter a number as the number of seconds between router query messages. The range is from 0 to 65535. The default is 30 seconds.
Defaults
30 seconds
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.11.3.0
Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100, S6010-ON, S3048-ON, and C9010.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\