Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 pim rp-address

Configure a static PIM rendezvous point (RP) address for a group. First-hop routers use this address to send register packets on behalf of the source multicast host.

Syntax
ipv6 pim [vrf vrf-name] rp-address address {group-address group-address mask} [override]

To remove an RP address, use the no ipv6 pim re-address address group-address mask [override] command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view IP PIM debugging messages corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
address
Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
group-address group-address mask
Enter the keywords group-address then the group address in the x:x:x:x::x format and then the mask in /nn format to assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
override
(OPTIONAL) Enter the keyword override to override the BSR updates with static RP. The override takes effect immediately during enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults
none
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.11.3.0
Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100, S6010-ON, S3048-ON, and C9010.
Usage Information

The device selects the RP based on the longest prefix match of the configured group address when both static and dynamic RPs are configured.

The override option allow you to use statically configured RP instead of the longest prefix match of the configured group address associated with a dynamic RP.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\