Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 pim spt-threshold

Specifies when a PIM leaf router should join the shortest path tree.

Syntax
ipv6 pim [vrf vrf-name] spt-threshold {infinity}

To return to the default value, use the no ipv6 pim spt-threshold command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view IP PIM debugging messages corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
infinity
Enter the keyword infinity to have all sources for the specified group use the shared tree and never join shortest path tree (SPT).
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.11.3.0
Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100, S6010-ON, S3048-ON, and C9010.
Usage Information
PIM leaf routers join the shortest path tree immediately after the first packet arrives from a new source.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\