Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 unicast-routing

Enable IPv6 unicast routing on the device.

Syntax
ipv6 unicast-routing

To disable unicast routing, use the no ipv6 unicast-routing command.

Defaults
Enabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant DellEMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.5(0.1)
Introduced on the Z9500.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.4.2.1
Introduced on the S-Series.
8.2.1.0
Introduced on the E-Series.
7.8.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information
Because this command is enabled by default, it does not appear in the running configuration. When you disable unicast routing, the no ipv6 unicast-routing command is included in the running configuration. Whenever unicast routing is disabled or re-enabled, DellEMC Networking OS generates a syslog message indicating the action.
Disabling unicast routing on an E-Series chassis causes the following behavior:
  • static and protocol learned routes are removed from RTM and from the CAM; packet forwarding to these routes is terminated
  • connected routes and resolved neighbors remain in the CAM and new IPv6 neighbors are still discoverable
  • additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no new adjacencies are formed
  • the IPv6 address family configuration (under router bgp) is deleted
  • IPv6 Multicast traffic continues to flow unhindered

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\