Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

management route

Configure a static route that points to the Management interface or a forwarding router.

Syntax
management route {ip-address mask | ipv6-address 1.1.1.1prefix-length} {forwarding-router-address | managementethernet | fortyGigE | vlan | tengigabitethernet }

To remove a static route, use the no management route command.

Parameters
ip-address mask
Enter an IP address (dotted decimal format) and mask (/prefix format) of the destination subnet.
ipv6-address prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format.

The range is from /0 to /128.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.
forwarding-router-address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format) of a forwarding router.
managementethernet
Enter the keyword managementethernet for the Management interface on the Primary RPM.
fortyGigE
Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan
Enter the keyword vlan to specify a vlan interface.
tengigabitethernet
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernet interface.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for forty gigabit, vlan, and tengigabit ethernet interfaces. Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000 and added support for IPv6.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.5.1.0
Introduced on the C-Series.
pre-6.1.1.0
Introduced on the E-Series.
Usage Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\