Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

match source-protocol

Specify matching source-protocol criteria while exporting or importing routes.

Syntax
match source-protocol {bgp | isis | ospf | connected | static}
Parameters
bgp
Enter the keyword bgp to leak or share routes corresponding to the BGP protocol.
isis
Enter the keyword isis to leak or share routes corresponding to the ISIS protocol.
ospf
Enter the keyword ospf to leak or share routes corresponding to the OSPF protocol.
connected
Enter the keyword connected to leak or share connected routes corresponding to the VRF.
static
Enter the keyword static to leak or share static routes corresponding to the VRF.
Command Modes
ROUTE MAP MODE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.
Usage Information

Specify the matching criteria only after defining a route-map. Before using this command, you must enter Route Map mode using the route-map route-map-name command. The match criteria that you specify is associated with the route-map that you define.

The export-target and import-target options support only the match protocol and match prefix-list options. Other options that you configure in the route-maps are ignored.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\