Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

match

Configure the packet type to match for which the UDF offset bytes have to be parsed.

Syntax
match l2ethertype ipv4 ipprotocol value vlantag tagStatus

To return to the default settings, use the no match l2ethertype ipv4 ipprotocol value vlantag tagStatus command.

Parameters
l2ethertype
Enter the keyword l2ethertype to match the L2 Ethertype.
ipv4
Enter the keyword ipv4 to match the IPv4 packet.
ipprotocol value
Enter the keyword ipprotocol then the option to match the IPv4 protocol. The options are:
  • IP protocol number. The range is from 0 to 255.
  • icmp — Internet control message protocol.
  • tcp — Transmission control protocol.
  • udp — User datagram protocol.
vlantag tagStatus
Enter the keyword vlantag then the option to match the VLAN packet. The options are:
  • any — Any VLAN packet.
  • double-tagged — Double tagged VLAN packet.
  • single-tagged — Single tagged VLAN packet.
  • untagged — Untagged VLAN packet.
Defaults
None
Command Modes
CONFIGURATION-UDF TCAM
Example
Dell(conf-udf-tcam)#match l2ethertype ipv4 ipprotocol 4 vlantag any
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.8(0.0)
Introduced on the S6000, Z9500, and S4048-ON.
Related Commands

udf-tcam — creates a context for UDF TCAM.

show config — displays the current UDF TCAM profile configuration.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\