Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

mtu

Enable the verification of the configured maximum transmission unit (MTU) value in the received RA packets.

Syntax
mtu value

To reset the MTU value, use the no mtu value command.

Parameters
value
Enter the maximum transmission unit value in bytes. The range is from 1,280 to 11,982 bytes.
Defaults
0
Command Modes
POLICY LIST CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the C9010.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.9(0.0)
Introduced on the Z9500.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.7(0.0)
Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\