Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

neighbor activate

This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI (Address Family Identifier/Subsequent Address Family Identifier).

Syntax
neighbor [ip-address | peer-group-name] activate

To disable, use the no neighbor [ip-address | peer-group-name] activate command.

Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
activate
Enter the keyword activate to enable the neighbor/peer group in the new AFI/SAFI.
Defaults

IPv4 Unicast – Enabled.

IPv6 Unicast – Disabled.

Command Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.12(1.0)
Introduced on the S5048F–ON.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
Usage Information
By default, when you create a neighbor/peer group configuration in the Router BGP context, this enables IPv4/Unicast AFI/SAFI. When you use activate in the new context, the neighbor/peer group enables for AFI/SAFI. It is possible to activate or de-activate a peer from the IPv4/IPv6 unicast address family.
NOTE: The no neighbor peer ip-address activate command takes precedence over the no neighbor peer-group-name activate command.

The following tables list the neighbor activation and its expected results for IPv4 and IPv6 address families:

Table 1. Neighbor activation and update status for peers activated for IPv4 address familyNeighbor IPv4 address family activation and its update status
S.No Peer – IPv4 address family Peer group Update status for IPv4 prefixes
1. Activate Activate Send Updates
2. Activate No-Activate Send Updates
3. No-Activate Activate Stop Updates
4. No-Activate No-Activate Stop Updates
Table 2. Neighbor activation and update status for peers activated for IPv6 unicast address familyNeighbor IPv6 unicast address family activation and its update status
S.No Peer– IPv6 unicast address family Peer group Update status for IPv6 prefixes
1. Activate Activate Send Updates
2. Activate No-Activate Send Updates
3. No-Activate Activate Send Updates
4. No-Activate No-Activate Stop Updates

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\