Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

neighbor distribute-list

Distribute BGP information via an established prefix list.

Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in | out}

To delete a neighbor distribution list, use the no neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in | out} command.

Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to apply the distribute list filter to all routers in the peer group.
prefix-list-name

Enter the name of an established prefix list.

If the prefix list is not configured, the default is permit (to allow all routes).

in
Enter the keyword in to distribute only inbound traffic.
out
Enter the keyword out to distribute only outbound traffic.
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
Usage Information
Other BGP filtering commands include: neighbor filter-list, ip as-path access-list, and neighbor route-map.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\