Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

neighbor peer-group (assigning peers)

Allows you to assign one peer to an existing peer group.

Syntax
neighbor {ip-address | peer-group peer-group-name} dmzlink-bw

To delete a peer from a peer group, use the no neighbor {ip-address | peer-group peer-group-name} command.

To disable dmzlink-dw for the peer group, use the no neighbor ip-address dmzlink-dw command.

Parameters
ip-address
Enter the IP address of the router to be included in the peer group.
peer-group-name
Enter the name of a configured peer group.
dmzlink-bw
Enter the keyword dmzlink-bw to attach a link bandwidth to received routes.
NOTE: If dmzlink-bw is configured for a peer, in order for the BGP peer to advertise the prefixes with dmzlink-bw attached to it, you must reset the the peer or peer-group using the clear ip bgp session command.
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added the dmzlink-bw parameter.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
Usage Information

You can assign up to 256 peers to one peer group.

When you add a peer to a peer group, it inherits all the peer group’s configured parameters. A peer cannot become part of a peer group if any of the following commands are configured on the peer:

if a neighbor’s configuration is more specific than its peer group’s configuration, the neighbor may retain its configuration after it is added to the peer group. The neighbor’s configuration does not affect outgoing updates.

A peer group must exist (be enabled) before you add a peer to it. If the peer group is disabled (shutdown), the peers within that group are also disabled (shutdown).

In BGP, you cannot associate a peer to a peer-group without configuring the remote-as for Internal BGP (IBGP) or External BGP (EBGP).

This command automatically restarts the neighbor session for the configuration to take effect.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\