Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ntp control-key-passwd

Configure control key password for NTPQ authentication. NTP control key supports encrypted and unencrypted option.

Syntax
ntp control-key-passwd [encryption-type] password

To delete the control key, use the no ntp control-key-passwd [encryption-type] password command.

Parameters
encryption-type
(OPTIONAL) Enter one of the following numbers:
  • 0 (zero) directs the system to store the password as clear text. It is the default encryption type when using the password option.
  • 7 (seven) indicates that a password is encrypted using a DES hashing algorithm. It specifies a hidden authentication data.
  • WORD is the un-encrypted (cleartext) authentication data.
password
Enter a string up to 32 characters as the password.
Defaults
NTPQ
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(1.0)
Introduced on the S4810 and S4820T.
9.14(0.0)
Introduced on the C9010, FN–IOM, MIOA, MXL, S3048–ON, S4048–ON, S4048T–ON, S5048F–ON, S6000, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Usage Information

NTP control key is not configured by default. If the encryption–type (0 or 7) is not specified, then 0 is selected by default.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\