Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ntp step-threshold

Configure the step-threshold time interval.

Syntax
ntp step-threshold value

To return to the default NTP step-threshold value, use the no ntp step-threshold command.

Parameters
value
Enter the threshold value in milliseconds. The range is from 128 to 5000 milliseconds (5 seconds).
Defaults
128 milliseconds
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command-Line Reference Guide.

Version
Description
9.14(2.3)
Introduced on the C9000, S3048-ON, S3100 series, S4048-ON, S4048T-ON, S5048F-ON, S6000, S6000-ON, S6010-ON, S6100-ON, and Z9100-ON.
Usage Information

The ntp step-threshold command is used to configure a step threshold value from 128 to 5000 milliseconds (5 seconds). You can use the no form of the command to reset to the default value of 128 milliseconds.

Example
DellEMC(config)# ntp step-threshold 5000

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\