Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

offset-list

Specify a number to add to the incoming or outgoing route metrics learned using RIP.

S4048–ON

Syntax
offset-list prefix-list-name {in | out} offset [interface]

To delete an offset list, use the no offset-list prefix-list-name {in | out} offset [interface] command.

Parameters
prefix-list-name
Enter the name of an established Prefix list to determine which incoming routes are modified.
offset
Enter a number from zero (0) to 16 to be applied to the incoming route metric matching the access list specified. If you set an offset value to zero (0), no action is taken.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults
Not configured.
Command Modes
ROUTER RIP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.5.1.0
Added support for 4-port 40G line cards.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
pre- 6.2.1.1
Introduced on the E-Series.
Usage Information
When the offset metric is applied to an interface, that value takes precedence over an offset value that is not extended to an interface.
Related Commands
  • ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\