Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

permit

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.

Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
  • Use the no seq sequence-number command syntax if you know the filter’s sequence number
  • Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Parameters
ip-protocol-number
Enter an IPv6 protocol number. The range is from 0 to 255.
icmp
Enter the keyword icmp to filter internet Control Message Protocol version 6.
ipv6
Enter the keyword ipv6 to filter any internet Protocol version 6.
tcp
Enter the keyword tcp to filter the Transmission Control protocol.
udp
Enter the keyword udp to filter the User Datagram Protocol.
Defaults
Not configured.
Command Modes
ACCESS-LIST
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\