Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

qos dscp-color-map

Configure the DSCP color map.

Syntax
qos dscp-color-map map-name

To remove a color map, use the no qos dscp-color-map map-name command.

Parameters
map-name
Enter the name of the DSCP color map. The map name can have a maximum of 32 characters.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.5(0.1)
Introduced on the Z9500.
9.7(0.0)
Introduced on the S6000-ON.
9.5.0.0
Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information
A color map outlines the codepoint mappings to the appropriate color mapping (green, yellow, red) for the traffic. The system uses this information use to handle the traffic on the interface based on the traffic priority and places it into the appropriate shaping queue. You cannot delete a DSCP color map when it is configured on an interface. If you do, all the DSCP values are set to green (low drop precedence). To delete the DSCP color map that is being used by one or more interfaces, remove the DSCP map from each interface.
Example
DellEMC(conf)#qos dscp-color-map mymap
Related Commands
  • qos dscp-color-map— associates the DSCP color map profile with an interface so that all IP packets received on it is given a color based on that color map.
  • dscp— sets the number of specific DSCP values for color map profile to yellow or red.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\