Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

redistribute

Redistribute information from another routing protocol throughout the OSPF process.

Syntax
redistribute {connected | isis | ospf | rip | static} [metric metric-value | metric-type type-value] [route-map map-name] [tag tag-value]

To disable redistribution, use the no redistribute {connected | isis | rip | static} command.

Parameters
connected
Enter the keyword connected to specify that information from active routes on interfaces is redistributed.
isis
Enter the keyword isis to specify that ISO IS-IS information is redistributed.
ospf
Enter the keyword ospf to specify that information corresponding to OSPF is redistributes.
rip
Enter the keyword rip to specify that RIP routing information is redistributed.
static
Enter the keyword static to specify that information from static routes is redistributed.
metric metric-value
(OPTIONAL) Enter the keyword metric then a number. The range is from 0 (zero) to 16777214.
metric-type type-value
(OPTIONAL) Enter the keywords metric-type then one of the following:
  • 1 = OSPF External type 1
  • 2 = OSPF External type 2
route-map map-name
(OPTIONAL) Enter the keywords route-map then the name of the route map.
tag tag-value
(OPTIONAL) Enter the keyword tag then a number. The range is from 0 to 4294967295.
Defaults
Not configured.
Command Modes
ROUTER OSPF
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Added support for Multi-Process OSPF.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
pre- 6.1.1.1
Introduced on the E-Series.
Usage Information
To redistribute the default route (0.0.0.0/0), configure the default-information originate command.

Despite removing an OSPF process globally, the OSPF process is not completely removed from the BGP configuration.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\