Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

remote-vtep-ip

Create a remote VTEP and associate it to specified VNIDs.

Syntax
remote—vtep—ip IP Address vni-profile profile name

To delete the remote VTEP, use the no remote—vtep—ip command.

Parameters
IP Address
Enter the IP Address of the remote VTEP.
vni-profile
Enter the keyword vni-profile followed by the profile name to which the remote VTEP has to be associated.
Defaults
None.
Command Modes
VXLAN-INSTANCE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Usage Information
Use this command to associate a specific VNID to a remote VTEP. Provide a valid profile name while associating to the remote VTEP.
NOTE: The remote VTEP IP Address cannot be any of the local IP Addresses configured in the switch.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\