Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

resequence access-list

Re-assign sequence numbers to entries of an existing access-list.

Syntax
resequence access-list {ipv4 | mac} {access-list-name StartingSeqNum Step-to-Increment}
Parameters
ipv4 | mac
Enter the keyword ipv4or mac to identify the access list type to resequence.
access-list-name
Enter the name of a configured IP access list, up to 140 characters.
StartingSeqNum
Enter the starting sequence number to resequence. The range is from 0 to 4294967290.
Step-to-Increment
Enter the step to increment the sequence number. The range is from 1 to 4294967290.
Defaults
None
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.11.1
Introduced on the Z9000.
8.1.1.0
Introduced on the E-Series (IPv4).
7.8.1.0
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information

When all sequence numbers are exhausted, this feature permits re-assigning a new sequence number to entries of an existing access-list.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\