Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

router-id

Designate a fixed router ID.

Syntax
router-id ip-address

To return to the previous router ID, use the no router-id ip-address command.

Parameters
ip-address

Enter the router ID in the dotted decimal format.

Defaults
The router ID is selected automatically from the set of IPv4 addresses configured on a router.
Command Modes

ROUTER OSPF for OSPFv2

ROUTER OSPFv3 for OSPFv3
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.12(1.0)
Introduced on the S5048F–ON.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.1.(0.0)
Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0
Introduced on the S4820T.
7.8.1.0
Added support for the C-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information

You can configure an arbitrary value in the IP address for each router. However, each router ID must be unique.

If this command is used on an OSPFv3 process that is already active (has neighbors), all the neighbor adjacencies are brought down immediately and new sessions are initiated with the new router ID.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\