Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

scheduler

Configure the method used to schedule priority traffic in port queues.

Syntax
scheduler value

To remove the configured priority schedule, use the no scheduler command.

Parameters
value
Enter schedule priority value. The range: strict: strict-priority traffic is serviced before any other queued traffic.
Defaults
Weighted Elastic Round Robin (WERR) scheduling is used to queue priority traffic.
Command Modes
POLICY-MAP-OUT-ETS
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information

dot1p priority traffic on the switch is scheduled to the current queue mapping. dot1p priorities within the same queue must have the same traffic properties and scheduling method.

ETS-assigned scheduling applies only to data queues, not to control queues.

The configuration of bandwidth allocation and strict-queue scheduling is not supported at the same time for a priority group. If you configure both, the configured bandwidth allocation is ignored for priority-group traffic when you apply the output policy on an interface.

If you enable this command for a QoS ETS output policy, no bandwidth percentage is assigned to the policy.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\