Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

sflow ingress-enable

Enable sFlow ingress on interfaces.

Syntax
sflow ingress-enable

To disable sFlow, use the no sflow ingress enable command.

Defaults
Disabled.
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.7(0.0)
Introduced on the S-Series, Z-Series, and MXL switch.
9.2(1.0)
Introduced on the Z9500.
Usage Information
When you enable ingress sFlow on an interface, flow sampling is done on any incoming traffic.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from the LAG port.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\