Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

show cam-acl-egress

Show information on FP groups allocated for egress ACLs.

Syntax
show cam-acl-egress
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.4.2.1
Introduced on the S-Series.
8.4.2.0
Introduced on the E-Series.
7.8.1.0
Introduced on the C-Series.
Example
DellEMC# show cam-acl-egress

-- Chassis Egress Cam ACL --
         Current Settings(in block sizes)
L2Acl   :         1
Ipv4Acl :         1
Ipv6Acl :         2

-- Stack unit 1 --
         Current Settings(in block sizes)
L2Acl   :         1
Ipv4Acl :         1
Ipv6Acl :         2

DellEMC#show cam-acl
Related Commands
  • cam-acl — configure CAM profiles to support IPv6 ACLs.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\