Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

show ipv6 management-route

Display the IPv6 static routes configured for the management interface.

Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
all
(OPTIONAL) Enter the keyword all to view all IP addresses assigned to all Management interfaces on the switch.
connected
(OPTIONAL) Enter the keyword connected to view only routes directly connected to the Management interface.
summary
(OPTIONAL) Enter the keyword summary to view a table listing the number of active and non-active routes and their sources.
static
(OPTIONAL) Enter the keyword static to view non-active routes also.
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.4.1.0
Introduced on the C- and E-Series.
8.3.7.0
Introduced on the S4810.
Example
DellEMC# show ipv6 management-route
IPv6 Destination   Gateway                 State
----------------    -------                -----
2001:34::0/64      ManagementEthernet 1/1  Connected
2001:68::0/64      2001:34::16             Active
DellEMC#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\