Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

show ipv6 multicast-cam

Display the content addressable memory (CAM) size and the portions allocated for IP multicast traffic.

Syntax
show ipv6 multicast-cam [linecard slot-id | port-set port-pipe | stack-unit unit-id]
Parameters
linecard slot-id
Enter the keyword linecard with a slot id to select the line card for which to gather information. The range of slot IDs is from 0 to 2.
port-set port-pipe
Enter the keyword port-set with a port-pipe number to select the port pipe for which to gather information. The range of port pipes is from 0 to 3.
stack-unit unit-id
Enter the keyword stack-unit with a unit-id number to select the stack unit for which to gather information.
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

9.11.3.0
Introduced on the C9000, S3048–ON, S3100, S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON and Z9100–ON.
Example
Dell# show ipv6 multicast-cam stack-unit 1 port-set 0

Group Address  : ff0e::228:1:1  
Source Address : 400::2      
VRF    : 1      
VlanId : 4095   
IPMC     : 609  
L2 Ports :  -   
L3 Ports : gi  1/10  

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\