Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

show ipv6 ospf interface

View OSPFv3 interface information.

Syntax
show ipv6 ospf [process-number] [vrf vrf-name] [interface]
Parameters
process-number
Enter the OSPF process number.
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the default VRF are displayed.
interface

(OPTIONAL) Enter one of the following keywords and slot/port or number information:

  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a port channel interface, enter the keywords port-channel then a number.
  • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults
None
Command Modes

EXEC

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF.
9.2(1.0)
Introduced on the Z9500.
9.2.(0.0)
Added support for showing BFD status on the S4820T, S4810, and Z9000.
9.1.(0.0)
Added support for OSPFv3 on the S4810 and Z9000.
8.3.19.0
Introduced on the S4820T.
7.8.1.0
Added support for the C-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information

If you enable BFD at the global level, show ipv6 ospf interface shows the BFD provisioning.

If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD interval timers.

Example
DellEMC# show ipv6 ospf 3 interface tengigabitethernet 1/2

TenGigabitEthernet 1/2 is up, line protocol is up
  Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217
  Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
  NetworkType BROADCAST, Cost: 1, Passive: No
  Transmit Delay is 100 sec, State DR, Priority 1
  Interface is using OSPF global mode BFD configuration.
  Designated router on this network is 11.1.1.1 (local)
  No backup designated router on this network
  Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5

DellEMC#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\