Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

show redundancy

Display the current redundancy configuration (status of automatic reboot configuration on stack management unit).

Syntax
show redundancy
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(2.0)
Introduced on the S3100 series.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
Usage Information
To modify your results, use the show redundancy [pipe] command, as follows:
  • except — show only text that doesn not match a pattern.
  • find — search for the first occurrence of a pattern.
  • grep — show only text that matches a pattern.
  • no-more — do not paginate the output.
  • save — save the output to a file.
Example
DellEMC#show redundancy

--  Stack-unit Status  --
------------------------------------------------
 Mgmt ID:                          1
 Stack-unit ID:                    1
 Stack-unit Redundancy Role:       Primary
 Stack-unit State:                 Active
 Stack-unit SW Version:            1-0(0-4812)
 Link to Peer:                     Up

--  PEER Stack-unit Status  --
------------------------------------------------
 Stack-unit State:                 Standby
 Peer Stack-unit ID:               2
 Stack-unit SW Version:            1-0(0-4812)

--  Stack-unit Redundancy Configuration  --
------------------------------------------------
 Primary Stack-unit:               mgmt-id    1
 Auto Data Sync:                   Full
 Failover Type:                    Hot Failover
 Auto reboot Stack-unit:           Enabled
 Auto failover limit:              3 times in 60 minutes

--  Stack-unit Failover Record  --
------------------------------------------------
 Failover Count:                   0
 Last failover timestamp:          None
 Last failover Reason:             None
 Last failover type:               None

--  Last Data Block Sync Record:  --
------------------------------------------------
 stack-unit Config:         succeeded  Apr 20 2016 11:44:04
             SSMGR:         succeeded  Apr 20 2016 11:44:04
   Start-up Config:         succeeded  Apr 20 2016 11:44:04
 Runtime Event Log:         succeeded  Apr 19 2016 15:36:45
    Running Config:         succeeded  Apr 19 2016 15:35:44
           ACL Mgr:         succeeded  Apr 19 2016 15:35:44
              LACP:         no block sync done
               STP:         no block sync done
              SPAN:         no block sync done
         CRYPTOMGR:         succeeded  Apr 19 2016 15:35:44


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\