Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

speed (Management interface)

Set the speed for the Management interface.

Syntax
speed {10 | 100 | 1000 | auto}

To return to the default setting, use the no speed command.

Parameters
10
Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100
Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
1000
Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s.
auto
Enter the keyword auto to set the interface to auto-negotiate its speed.
Defaults
auto
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.11.1
Introduced on the S55, S60, and S4810
8.1.1.0
Introduced on the E-Series.
7.5.1.0
Introduced on the C-Series.
pre-Version 6.2.1.0
Introduced on the E-Series.
Usage Information
This command is found on the Management interface only.
Related Commands
  • interface ManagementEthernet — configure the Management port on the system (either the Primary or Standby RPM).
  • management route — configure a static route that points to the Management interface or a forwarding router.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\