Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

stack-unit portmode quad

Configures the list of dynamic fan-out capable ports.

Syntax
stack-unit [stack-unit number] port port-number portmode quad

To remove the quad-port configuration, use the command.

Parameters
stack-unit number
Enter the port number. The range is from 1 to 6.
Defaults
49,50,51,52,53,54
Command Modes
CONFIGURATION
Command History
Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.7(0.0)
Introduced on the S6000 and S6000–ON.
Usage Information

For the new quad port profile configuration to take effect, you must first save changes and then reload the switch.

Example
Dell(conf)#stack-unit 1 port 49 portmode quad
Warning: Enabling Quad mode on stack-unit 1 port 49. Please verify whether the configs related to interface Fo 1/49  are cleaned up before proceeding further.
[confirm yes/no]:yes
Quad mode is enabled on stack-unit 1 port 49
Dell(conf)#Jan 1 13:37:01: %STKUNIT1-M:CP %IFMGR-5-DYNAMIC_FANOUT: Port 49 in slot 1 has been fanned-out 
TenGigabitEthernet 1/49/1     unassigned      NO  Manual administratively down down
TenGigabitEthernet 1/49/2     unassigned      NO  Manual administratively down down
TenGigabitEthernet 1/49/3     unassigned      NO  Manual administratively down down
TenGigabitEthernet 1/49/4     unassigned      NO  Manual administratively down down 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\