Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

timers bgp extended

Adjust the BGP idle holdtime for all the BGP neighbors.

Syntax
timers bgp extended idle-holdtime

To return to the default, use the no timers bgp extended command.

Parameters
extended idle-holdtime
Enter a number for the time interval, in seconds, for the peer to be idle state. The range is from 1 to 32767. The default is 15 seconds.
Defaults

The default idle-holdtime is 15 seconds.

Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.0)
Introduced on the C9010, MXL, FN IOM, S3100 series, S3048–ON, S4048–ON, S4048T-ON, S5048F-ON, S6000, S6010–ON, S6100–ON, Z9100–ON, Z9500, and S6000–ON.
Usage Information

The peer remains in idle state based on the configured idle-holdtime. The less the idle-holdtime, lesser the peer in idle state.

For the new idle-holdtime to take effect, you need to shutdown all the peers manually using neighbor shutdown command and enable the peers again.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\