Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

upstream

Assign a port or port-channel to the uplink-state group as an upstream interface.

Syntax
upstream interface

To delete an uplink-state group, use the no upstream interface command.

Parameters
interface
Enter one of the following interface types:
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] | slot/port[/subport]-range
  • 40-Gigabit Ethernet:fortyGigE {slot/port}
  • Port channel: port-channel {1–128 | port-channel-range}

Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: gigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5. A comma is required to separate each port and port-range entry.

If a 40G port is fanned-out into 10G ports, the range is entered as slot/sort/subport-slot/port/subport.

Defaults
none
Command Modes
UPLINK-STATE-GROUP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10.0.2
Introduced on the Z9100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.10(0.0)
Introduced on the S3148.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.4.2.3
Introduced on the S-Series S50.
Usage Information

You can assign physical port or port-channel interfaces to an uplink-state group.

You can assign an interface to only one uplink-state group. Configure each interface assigned to an uplink-state group as either an upstream or downstream interface, but not both.

You can assign individual member ports of a port channel to the group. An uplink-state group can contain either the member ports of a port channel or the port channel itself, but not both.

Example
DellEMC(conf-uplink-state-group-16)# upstream tengigabitethernet 1/10-15
DellEMC(conf-uplink-state-group-16)#
Related Commands
  • downstream — assigns a port or port-channel to the uplink-state group as a downstream interface.
  • uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\