Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.

Syntax
vlan-stack access

To remove access port designation, use the no vlan-stack access command.

Defaults
Not configured.
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the C-Series and S-Series.
E-Series original Command
Usage Information

Prior to enabling this command, to place the interface in Layer 2 mode, enter the switchport command.

To remove the access port designation, remove the port (using the no member interface command) from all stackable VLAN-enabled VLANs.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\