Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

vxlan-instance (VAP)

To configure a VXLAN-Access Port (VAP) in to VXLAN-instance

Syntax
vxlan-instance instance ID

To unconfigure VAP, use the no vxlan-instance 1 command.

Parameters
instance ID
Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial release.
Defaults
Disabled
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.10(0.1P10)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S4048–ON.
9.4(0.0)
Introduced on the S6000.
Usage Information
You must disable vxlan-instance before unconfiguring VAP.
Related Commands
feature vxlan — Enable VXLAN configuration globally on the platform.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\