Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Configuration Guide for the S4048–ON System 9.14.2.5

PDF

Add Units to an Existing Stack

You can add units to an existing stack in one of three ways.

  • By manually assigning a new unconfigured unit a position in an existing stack.
  • By adding a configured unit to an existing stack.
  • By merging two stacks.
If you are adding units to an existing stack, you can either:
  • allow Dell EMC Networking OS to automatically assign the new unit a position in the stack, or
  • manually determine each units position in the stack by configuring each unit to correspond with the stack before connecting it.
  • If you add a unit that has a stack number that conflicts with the stack, the stack assigns the first available stack number.
  • If the stack has a provision for the stack-number that will be assigned to the new unit, the provision must match the unit type, or Dell EMC Networking OS generates a type mismatch error.

After the new unit loads, it synchronizes its running and startup configurations with the stack.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\