Dell Configuration Guide for the S4048–ON System 9.14.2.6

Displaying Remote-Port Mirroring Configurations

To display the current configuration of remote port mirroring for a specified session, enter the show config command in MONITOR SESSION configuration mode.

DellEMC(conf-mon-sess-2)#show config
!
monitor session 2 type rpm
 source fortyGigE 1/52 destination remote-vlan 300 direction rx
 source Port-channel 10 destination remote-vlan 300 direction rx
 no disable

To display the currently configured source and destination sessions for remote port mirroring on a switch, enter the show monitor session command in EXEC Privilege mode.

DellEMC(conf)#do show monitor session
  SessID  Source         Destination         Dir  Mode  Source IP      Dest IP
  ------  ------         -----------         ---  ----  ---------      --------
     1   remote-vlan 100   Fo 1/49           N/A  N/A      N/A            N/A
     1   remote-vlan 100   Po 100            N/A  N/A      N/A            N/A
     2   Fo 1/50           remote-vlan 300   rx   Port     N/A            N/A
     2   Po 10             remote-vlan 300   rx   Port     N/A            N/A

To display the current configuration of the reserved VLAN, enter the show vlan command.

DellEMC#show vlan

Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C - Community, I - Isolated
       O - Openflow
Q: U - Untagged, T - Tagged
   x - Dot1x untagged, X - Dot1x tagged
   o - OpenFlow untagged, O - OpenFlow tagged
   G - GVRP tagged, M - Vlan-stack
   i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged

    NUM    Status    Description                     Q Ports
*   1      Inactive
R   100    Active                                   T Fo 1/49
R   300    Active                                   T Fo 1/51