Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

area authentication

Configure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.

Syntax
area area-id authentication ipsec spi number {MD5 | SHA1} [key-encryption-type] key
Parameters
area area-id

Area for which OSPFv3 traffic is to be authenticated. For area-id, you can enter a number.

The range is from 0 to 4294967295.

ipsec spi number

Security Policy index (SPI) value that identifies an IPsec security policy.

The range is from 256 to 4294967295.

MD5 | SHA1

Authentication type: Message Digest 5 (MD5) or Secure Hash Algorithm 1 (SHA-1).

key-encryption-type

(OPTIONAL) Specifies if the key is encrypted.

The values are 0 (key is not encrypted) or 7 (key is encrypted).

key

Text string used in authentication.

For MD5 authentication, the key must be 32 hex digits (non-encrypted) or 64 hex digits (encrypted).

For SHA-1 authentication, the key must be 40 hex digits (non-encrypted) or 80 hex digits (encrypted).

Defaults
Not configured.
Command Modes
ROUTER OSPFv3
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.1.(0.0)
Introduced on the S4810 and Z9000.
8.3.19.0
Introduced on the S4820T.
8.4.2.0
Introduced on the E-Series.
Usage Information
Before you enable IPsec authentication on an OSPFv3 area, you must first enable OSPFv3 globally on the router. Configure the same authentication policy (same SPI and key) on each interface in an OSPFv3 link.

An SPI number must be unique to one IPsec security policy (authentication or encryption) on the router.

If you have enabled IPsec encryption in an OSPFv3 area with the area encryption command, you cannot use the area authentication command in the area at the same time.

The configuration of IPsec authentication on an interface-level takes precedence over an area-level configuration. If you remove an interface configuration, an area authentication policy that has been configured is applied to the interface.

To remove an IPsec authentication policy from an OSPFv3 area, enter the no area area-id authentication spi number command.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\