Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

arp additional-refresh

Perform additional ARP refresh on the VLTi (ICL).

Syntax
arp additional-refresh

To disable additional ARP refresh on VLTi, use the no arp additional-refresh command.

Defaults
Enabled
Command Modes
VLT DOMAIN
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(2.7)
Introduced on all platforms.
Usage Information
To disable additional ARP refresh on VLTi, use the no arp additional-refresh command. To reenable additional ARP refresh on VLTi, use the arp additional-refresh command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\