Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

arp inspection-limit

Configure dynamic ARP inspection rate-limit to verify the rate of ARP packet received in a port on a specific interval.

Syntax
arp inspection-limit {rate pps [interval seconds]}
Defaults
None
Command Modes
INTERFACE CONFIGURATION
Parameters
rate pps
Enter the keyword rate then the packet per second (pps) value. The range is from 1 to 2048. The default is 15.
interval seconds
(Optional) Enter the keyword intervalthen the burst interval in seconds. The range is from 1 to 15. The default is 1.
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(1.0)
Introduced on the S3048-ON, S4048-ON, S4048T-ON, S3100 Series, Z9100-ON, S6100-ON, S6000, S6000-ON, S6010-ON, S5048F-ON, S4810, S4820T, FN IOM and MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\