Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

cam-acl-vlan

Specify the number of VFP blocks allocated to OpenFlow.

Syntax

cam-acl-vlan {default | vlanopenflow {0|1}}

Defaults
Disabled.
Parameters
default
Reset VLAN CAM ACL entries to default settings
vlanopenflow
Enter the number 1 to allocate VFP blocks and enable OpenFlow.

(Default) Enter the number 0 to disable OpenFlow.

Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.1.(0.0)
Introduced on S4810.
8.3.19.0
Introduced on the S4820T.
Usage Information

Reboot the switch after changing the parameter values for changes to take effect.

For platform-specific instructions about using this command, see the SDN section of the Dell EMC Networking OS Configuration Guide.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\