Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

cam-threshold

Configure CAM threshold value for sending the syslog message on CAM usage. Configure silence period for stop receiving syslog message on CAM usage.

Syntax

cam-threshold threshold {default | threshold-percent} silence-period {default | silence-period-value}

Defaults

Enabled

Parameters
threshold default

Enter the keyword default for CAM usage threshold for notification of the CAM usage through syslog message. The default threshold value is 90 percent.

threshold threshold-percent

Enter the threshold percent for notification of the CAM usage through syslog message. The range is from 1 to 100 percent.

silence-period default

Enter the keyword default to set the silence period for receiving syslog message regarding CAM usage for CAM region, slot/portpipe. The default silence period is 0 seconds.

silence-period silence-period-value

Enter the silence period for stop receiving syslog message for the respective CAM region, slot/portpipe. The range is from 0 to 65535 seconds.

Command Modes
CONFIGURATION
Supported Modes
Command History
Version
Description
9.14.1.0
Introduced on the S4810 and S4820T.
9.13.0.0
Introduced on the MXL, FN IOM, S5000, S4048-ON, S6000, S6000-ON, S3048-ON, S3100 Series, C9010, S4048T-ON, Z9500, Z9100-ON, S6100-ON, S6010-ON.
Usage Information

The no cam-threshold command will set the CAM threshold to 90 percent and silence period to 0.

The CAM threshold and silence period configuration is applicable only for Ingress L2, IPv4, IPv6 and Egress L2, IPv4, and IPv6 ACL CAM groups. For other ACL CAM regions, the CAM threshold and silence period is not configurable and the values are fixed to 90 percent and 0 respectively.

Example
DellEMC(conf)#cam-threshold threshold 2 silence-period  2
DellEMC(conf)#do show running-config | g cam-threshold
cam-threshold threshold 2 silence-period 2

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\