Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

clear ipv6 mld snooping groups

Clear entries from the group cache table.

Syntax
clear ipv6 mld snooping groups [interface | group-address]
Parameters
interface
Enter the following keywords and slot/port or number information:
  • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information.
  • For a Port Channel interface, enter the keywords port-channel then a number.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
group-address
(OPTIONAL) Enter the group address in the following format: x:x:x:x::x. The :: notation specifies successive hexadecimal fields of zero.
Defaults
None.
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.0)
Introduced on the S3048–ON, S4048–ON, S4048T-ON, S5048F-ON, S6000–ON, S6010–ON, S6100–ON, Z9100–ON, S3100, and C9010.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\