Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

crypto ipsec policy

Create a crypto policy used by ipsec.

Syntax
crypto ipsec policy name seq-num ipsec-manual

To delete a crypto policy entry, use the no crypto ipsec policy name seq-num ipsec-manual command.

Parameters
name
Enter the name for the crypto policy set.
seq-num
Enter the sequence number assigned to the crypto policy entry.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(0.2)
Introduced on the Z9000, S4810, and S4820T.
9.2(1.0)
Introduced on the Z9500.
Usage Information
This command creates a crypto policy entry and enters the crypto policy configuration mode for configuring the flow parameters.
Example
Dell(conf)# crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\