Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

dcb-buffer-threshold

Configure the profile name for the DCB buffer threshold.

Syntax
dcb buffer—threshold profile-name
Parameters
profile-name
Enter the name of the profile, which can be a string of up to 32 characters in length.
Default
None
Command Modes
CONFIGURATION mode
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S4048-ON.
9.7(0.0)
Introduced on the S6000-ON and Z9500.
9.6(0.0)
Introduced on the S5000.
9.3(0.0)
Introduced on the S4810, S4820T, and S6000.
Usage Information
When you enter the profile name, you enter the DCB buffer threshold configuration mode. You can specify the shared buffer threshold limit, the ingress buffer size, buffer limit for pausing the acceptance of packets, and the buffer offset limit for resuming the acceptance of received packets.
Example
DellEMC(conf)#dcb-buffer—threshold test
Example of commands in dcb buffer—threshold mode
priority value buffer-size size pause-threshold threshold-value resume-offset threshold-value shared-threshold-weight size
DellEMC(conf-dcb-buffer-thr)#priority 0 buffer-size 52 pause-threshold 16 resume-offset 10 shared-threshold-weight 7
priority value buffer-size size pause-threshold threshold-value peak-headroom headroom-value resume-offset threshold-value shared-threshold-weight size
DellEMC(conf-dcb-buffer)#priority value buffer-size size pause-threshold threshold-value peak-headroom headroom-value resume-offset threshold-value shared-threshold-weight size

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\