Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

default-information originate

Configure the Dell EMC Networking OS to generate a default external route into an OSPFv3 routing domain.

Syntax
default-information originate [always] [metric metric-value] [metric-type type-value] [route-map map-name]

To return to the default values, use the no default-information originate command.

Parameters
always
(OPTIONAL) Enter the keyword always to specify that default route information must always be advertised.
metric metric-value
(OPTIONAL) Enter the keyword metric then a number to configure a metric value for the route. The range is from 1 to 16777214.
metric-type type-value
(OPTIONAL) Enter the keywords metric-type then an OSPFv3 link state type of 1 or 2 for default routes. The values are:
  • 1 = Type 1 external route
  • 2 = Type 2 external route
route-map map-name
(OPTIONAL) Enter the keywords route-map then the name of an established route map.
Defaults
Disabled.
Command Modes
ROUTER OSPFv3
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.1.(0.0)
Introduced on the S4810 and Z9000.
8.3.19.0
Introduced on the S4820T.
7.8.1.0
Added support for C-Series.
7.4.1.0
Introduced on the E-Series.
Related Commands
  • redistribute — redistribute routes from other routing protocols into OSPFv3.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\